Veilige betaling
Via iDeal, bankoverschrijving
of pinnen/contant bij ophalen
Grote voorraad
Ook apparatuur uit
het hoge segment
100% verzekerd
Dubbel verpakt en
verzekerd per PostNL

Icom IC-F1000D Digitaal+Analoog

Icom IC-F1000D

The IC-F1000D/F2000D can program Type-D single-site trunking and digital conventional modes as well as analogue mode per channel. The IDAS digital mode employs 4-level FSK modulation and the NXDN™ common air interface, offering true 6.25kHz spectrum efficiency, higher security and better audio clarity – even at the fringes of the communication range.

Lees meer..

Beschikbaarheid: Op voorraad

€ 289,00

IDAS™ Digital Mode Operation
The IC-F1000D/F2000D can program Type-D single-site trunking and digital conventional modes as well as analogue mode per channel. The IDAS digital mode employs 4-level FSK modulation and the NXDN™ common air interface, offering true 6.25kHz spectrum efficiency, higher security and better audio clarity – even at the fringes of the communication range.

The following IDAS features are programmable:
• PTT ID (TX)
• Individual/group calls
• Radio check (RX)
• Stun/Kill/Revive (RX)
• Remote monitor (RX)
• Emergency (TX)
• Call alert (RX)
• Digital voice scrambler (15-bit)
• Status Call (Power ON/OFF status and GPS request)
• Voting scan for multi-site conventional operation

Intelligent Emergency Function
To assist in worker safety, the IC-F1000D/F2000D has three emergency related functions: motion detection, man down and lone worker functions. If one of these functions are activated, the transceiver automatically enters an emergency phase and starts counting down to send an emergency signal. The built-in motion sensor detects position, state of motion and non-motion.

Optional GPS Speaker-Microphone
With the optional GPS speaker-microphone, HM-171GPW, GPS position data can be attached to a voice or data transmission such as responding a GPS request status call.

IP67 Waterproof and Dust-tight Protection
While the body is compact, the IC-F1000D/F2000D has rugged construction providing superior protection against water (1m depth for 30 minutes), dust, sand, mud and other objects. The radio is also tested to MIL-STD 810 specifications. It can withstand harsh use.

Slim, Compact and Lightweight
The IC-F1000D/F2000D has a compact 52.2×111.8×30.3mm body and weighs only 260g (with BP-280 battery pack and belt clip). It's easy to carry around anywhere.

Easy to Hear in a Noisy Environment
The large 36mm speaker of the transceiver provides clear 800mW* audio. The built-in BTL amplifier increases the audio output power and delivers loud and intelligible voice to a radio operator working in noisy environments.
* Typical with internal speaker.

Built-in 5-Tone (Analogue mode)
The IC-F1000D/F2000D has built-in 5-Tone, CTCSS and DTCS signaling capability for analogue mode group communication and selective calling. The IC-F1000D/F2000D can be used as an analogue transceiver ready for future digital migration.

Long-Lasting Battery Pack
The large capacity waterproof battery pack, BP-280 (2400mAh typ.), provides 18 hours of operating time*. The supplied rapid charger BC-213 charges the BP-280 in 3.5 hours.
* Tx: Rx: Standby=5:5:90. Power save function ON. 

GENERAL
Frequency coverage (MHz): 136–174MHz
Number of channels: 16 channels
Type of emissions: 16K0F3E, 11K0F3E, 8K50F3E, 4K00F1E/D
Channel spacing: 30KHz, 15KHz, 6.25KHz, 25KHz, 12.5KHz, 6.25KHz
Power supply requirement: 7.5V DC nominal
Current drain:
- TX High: 1.3A
- RX Max. auidio/ Sandby: 400mA (Internals SP) / 110mA
Antenna impedance: 50Ω
Operating temperature range: -30°C to 60°C; –22°F to +140°F (radio specifications)
Dimensions (W×H×D) (Projections not included): 52.2×111.8×30.3 mm; 2.06×4.4×1.19 in (With BP-280)
Weight: 260g; 9.17oz (With MB-133 and BP-280)

TRANSMITTER
Output power: 5W, 2W, 1W (Hi, L2, L1)
Max. frequency deviation: ± 5.0kHz/±2.5kHz (Wide/Narrow)
Frequency stability: ±1.0ppm
Spurious emissions: 70dB min.
FM hum and noise: 46/40dB typ. (Wide/Narrow)
Audio harmonic distortion: 2.0%/1.1% typ. (W/N) (AF 1kHz 40% deviation)
FSK error: 5.0% max.
Ext. microphone connector: 3-conductor 2.5 (d) mm (1⁄10")⁄2.2kΩ

RECEIVER
Sensitivity:
- (at 12dB SINAD): 0.21μV typ. (Analog)(W/N)
- (at 5% BER): –8dBμV emf typ. (Digital)
Adjacent channel selectivity: 77/69/59dB typ. (W/N/D)
Spurious response: 80dB min.
Intermodulation: 75/75/71dB typ. (W/N/D)
Hum and noise: 47/43dB typ. (W/N)
Ext. speaker connector: 2-conductor 3.5 (d) mm (1⁄8″)/8Ω
Audio output power (at 5% distortion):
- Internal SP (w/12Ω load): 800mW typ. (at 5% distortion)
- External SP (w/8Ω load): 400mW typ. (at 5% distortion)

Schrijf uw eigen review
  1 ster 2 sterren 3 sterren 4 sterren 5 sterren
Ons
Product